Sounds like the SATA AHCI driver is not installed corectly or not installed at all. What does it show under device manager?
I have installed the driver from the intel site, but when I activate the RAID or SATA in hte BIOS Windows Blue Screens me. If I leave it in IDE it works fine. It show a marvell 61xx RAID Card. I need Mirroring on this box. I have tried to use the F6 durring install and I get a blue screen right after it loads the driver. Any ideas what I can do. I have build 3 PC like this one with no problem. I have even tried an other motherboard same result.
Thank you for any help,
You need check your disk, when it can run in IDE mode, but I turn on the RAID or SATA in the BIOS, you can use hddscan to scan storage device for bad-blocks, it is free for low-level scaning. goodlucky.
Moving this thread to our Desktop Board section of our Support Community.
Mike (Open Port Community Manager)