Through Serial-over-LAN and IDE-Redirect remote installation of OS, OS installation can not see the screen

[idata]

I use Intel AMT Commander, set IDE-Redirect, and send command "reboot to Redirect Cd-rom",

the remote computer is reboot, and use the console cd-drive (WinXP installation disk) boot, Star to Setup XP

but the operating system interface can not be showed in the console ,

Is not the console only display characters, unable to show picture

[idata]

No, it can't show GUI. As what AMT uses is SOL (serial over LAN) now, does not support GUI.

-Jen

[idata]

How to achieve remote re-install the operating system,

in IDE-Redirect mode

[idata]

There are several ways you can do that, such as you can use Ghost to restore the system from a image ( quiet installation parameters needed for ghost, thus you dont need to interact with ghost GUI); and you can use WinPE image with remote destop appliance on it, when you lunch WinPE via IDE-R, then you can use the remote desktop to access the machines then do what you want.

-Jen