3 Replies Latest reply on Jan 20, 2011 11:23 PM by softarts

    X520-SR2 doesn't work on HP DL380 G6 server?

    softarts

      firstly I installed the X520-SR2 on a hypertown server, it is OK

       

      (Intel(R) Xeon(R) CPU           E5440  @ 2.83GHz)

       

      but It failed to initialize when I move it to a HP DL380(Intel(R) Xeon(R) CPU E5540  @ 2.53GHz,

      http://h10010.www1.hp.com/wwpc/us/en/sm/WF05a/15351-15351-3328412-241644-241475-3884082.html )

       

      And it report these errors:

       

      Oct 18 04:23:17 linaspl50 kernel: [ 2325.038363] Intel(R) 10 Gigabit PCI Express Network Driver - version 3.0.12-NAPI Oct 18 04:23:17 linaspl50 kernel: [ 2325.038371] Copyright (c) 1999-2010 Intel Corporation.

      Oct 18 04:23:17 linaspl50 kernel: [ 2325.038413] ixgbe 0000:0a:00.0: PCI INT A -> GSI 31 (level, low) -> IRQ 31 Oct 18 04:23:17 linaspl50 kernel: [ 2325.038458] ixgbe 0000:0a:00.0: setting latency timer to 64 Oct 18 04:23:20 linaspl50 kernel: [ 2328.472454] ixgbe: 0000:0a:00.0: ixgbe_probe: failed to load because an unsupported SFP+ module type was detected.

      Oct 18 04:23:20 linaspl50 kernel: [ 2328.472457] Reload the driver after installing a supported module.

      Oct 18 04:23:20 linaspl50 kernel: [ 2328.472479] ixgbe 0000:0a:00.0: PCI INT A disabled Oct 18 04:23:20 linaspl50 kernel: [ 2328.472499] ixgbe 0000:0a:00.1: PCI INT B -> GSI 39 (level, low) -> IRQ 39 Oct 18 04:23:20 linaspl50 kernel: [ 2328.472529] ixgbe 0000:0a:00.1: setting latency timer to 64 Oct 18 04:23:24 linaspl50 kernel: [ 2331.895676] ixgbe: 0000:0a:00.1: ixgbe_probe: failed to load because an unsupported SFP+ module type was detected.

      Oct 18 04:23:24 linaspl50 kernel: [ 2331.895678] Reload the driver after installing a supported module.

      Oct 18 04:23:24 linaspl50 kernel: [ 2331.895692] ixgbe 0000:0a:00.1: PCI INT B disabled

       

      I also tried to use YAST(SUSE Linux11+SP1,kernel 2.6.32) to configure the NIC,it said "bus error maybe due to firmware missing." something like that

       

       

      when I reboot the machine, it shows EEPROM checksum is invalid followed by kernel panic.

       

      Thanks a lot!