0 Replies Latest reply on Jul 22, 2010 4:13 PM by jonathan.ross

    SCC Configuration problem & solution

    jonathan.ross

      After an MCPC reboot (which usually worked)  I could not run “SccBmc –I” without getting the error message:

      ERROR: initializeSysIF(): Failed to open PCIe driver device. Driver devices not installed/available…

       

      Another symptom was that the interface 'crb0' did not show up in ifconfig's output.

       

      I tried powering off the board through the BMC and rebooting the MCPC, but still got the same messages.

       

      The solution was as follows:

      • run /opt/sccKit/current/firmware/install.csh

      • power cycle board

          sccBmc -c "power off"

          sccBmc -c "power on"

      • reboot the MCPC

       

      On reboot full functionality was restored.