2 Replies Latest reply on Aug 20, 2018 4:05 AM by Intel Corporation

    Multicamera Sync HW Setup

    wormyrocks

      Hi all,

       

      I'm trying to implement multicamera hardware sync for point cloud capture, with simple passive ESD protection as described in the white paper. I ordered 4x D415 and all the connectors and cables from Digi-Key as instructed.

      Screen Shot 2018-08-14 at 10.37.47 AM.png

      I'm curious about how everyone who has built this is handling the physical connections between the cameras, specifically the cleanest way to attach passive components and connect the ground and sync cables. Are folks just soldering together the connectors on the ends of the shielded cables? What's the best way to get the parallel RC's as close to the camera as possible, deadbug SMTs or forcing through-hole leads into the connector crimps? Is there a reference design for a breakout PCB to handle all these connections?

       

      Thanks all!