I'm using the Quartus Prime Programmer software to program an Intel Max 10 device with an Altera USB Blaster II. It works fine after I manually start the program and add the file and device and press Start. But can I make a single command that I can run that will start the Programmer software, and add the programming file and device too? Like Quartus_pgmw -<file.pof>. So far it only starts the programming software but doesn't load a file. I can't find any help files that describe this process. The point of this exercise is to shorten the amount of time it takes to process a DUT through a program and test process and eliminate any mistakes a test operator could make. Thanks for any help you might provide!
Hello, Kurdle. I will be more than glad to assist you.
In this case, for you to receive better assistance, please share your issue with the Intel® Max® 10 Support Team so they can help you further: https://www.intel.com/content/www/us/en/programmable/products/fpga/max-series/max-10/support.html