3 Replies Latest reply on Jun 11, 2018 6:56 AM by MartyG

    D435 without USB2.0 lines


      Dear colleagues,


      I am using D435 camera with a Jetson TX2 + Carrier board.

      This carrier board USB 3.0 port has not USB 2.0 lines (D+ and D-), this port  was designed to use SR300 camera.

      I have performed some tests, and I observe as follows:


      - When all system starts, D435 is not found.

      - Once Jetson TX2 is turned on, if D435 is unplugged and then plugged again (USB port physically), the camera is then found and I can eventually get infrared, depth and RGB images.


      Could be any additional potential issue when using the camera without D+ and D- lines.


      Looking forward to hearing from you, thanks and regards.