0 Replies Latest reply on Feb 9, 2018 8:34 AM by Mikann

    I can't complete setup wifi on edison

    Mikann

      Hi,

      I'm working on edison (arduino bord)

       

      I have flashed edison bord and tried to setup wifi by using "configure_edison --wifi"

      I finished all the operations with PUTTY.

       

      But I can't access edison's page As below.

      「edison セットアップ wifi」の画像検索結果

      1. To verify the connectivity, ping your board from another computer on the same network using the IP address obtained above. Alternately, you can access your board by typing in its IP address into the browser of another computer on the same network. (from IoT)

       

       

       

      On my case, when I entered the IP address, such a page was displayed

      b.png

      it says "This site can't be reached.192.168.1.17 refused to conect."

       

      I tried the same thing again after I flashed the board.

      But the results were the same.

       

      Please tell me what to do to solve this.

      If there is a possibility of solving even a little.