11 Replies Latest reply on Dec 28, 2017 2:47 PM by Intel Corporation

    Rebuilding the failed System disk in Raid 1

    Oliver33

      Hi guys,

       

      I recently had an issue with Raid 1 in one of the PCs. The status was showing Failed.

       

      It turned out that the System Disk failed. I reset this hard drive to Non-Raid, replaced the hard drive with a new one and added it to the Raid. After that the status changed to Degraded, however, it was trying to boot from the hard disk I just installed.

       

      Is there any way that I can use the Recovery volume (the other hard drive which is working fine) as a System disk so that the newly added disk gets mirrored?

       

      I'm asking because I usually had the Recovery volume failing so after replacing it and adding it to the Raid, it will rebuild fine, but I've never had a System disk failing.

       

      Thank you!