Was able to get it to show up now. Tried following the directions to change to client mode, but the commands did not work. Do you have to flash the system when you receive your drone? Can you not just work on the default that it is shipped with? Otherwise, I suppose I will try flashing it to the latest version, and see if that helps. For the directions on flashing, it says a keyboard/mouse/monitor is not required. How do you go about the flashing process which requires typed commands into the terminal then?
This message was posted on behalf of Intel Corporation
The Intel Aero RTF drone will not have the latest image installed out of the box. The latest image (v1.6) can be found in the below link:
Please note the latest image requires an update to the BIOS, FPGA and Flight Controller which is all included in the image.
In regards to the flashing process, you will need a keyboard to be able to enter the BIOS and boot from the USB drive containing the latest image. Instruction on how to flash the board can be found in the following github wiki link: