1 of 1 people found this helpful
You should be able to connect the RealSense R200 camera to the USB3.0 OTG port on the Aero Compute board and run the cpp-multicam. I ran a quick test with and i was able to see both RealSense cameras with the cpp-multicam example.
Please note that a powered USB 3.0 hub is required for the RealSense cameras.
Thank you for your reply.
I have been using USB3.0 HUB which can supply power up to 20W.
However, my additional R200 could not be recogonized with "cpp-multicam" example (on my RTF with firmware v1.5.1) .
Could you tell me what USB3.0 HUB you are using and what is your firmware version?
I am using an Anker hub that we purchased from Amazon. The Intel Aero is running image v1.5.1 with bios v01.00.13.I noticed some error messages when connecting the RealSense camera after the board boots. The messages went away when connecting the RealSense camera prior to powering the board.
There are some known issues with the RealSense camera not working correctly when using different cables and/or hubs. You can find RealSense reported bugs here: https://github.com/IntelRealSense/librealsense
Hope this helps!
Thank you for your detailed suggestion.
We can buy Anker's hub also in Japan.
Therefore, I will retry after buying that.