4 Replies Latest reply on Nov 6, 2017 11:10 PM by ctan94x_intel

    Flashing Custom board with IntelCurie (C1000) via Jtag (olimex-arm-usb-ocd-h)

    eugene.redkin

      Helllo! When I'try to flash I obtained next error log:

      Open On-Chip Debugger 0.8.0-dev-g377d3f24-dirty (2017-04-11-19:24)

      Licensed under GNU GPL v2

      For bug reports, read

          http://openocd.sourceforge.net/doc/doxygen/bugs.html

      Info : only one transport option; autoselect 'jtag'

      adapter speed: 1000 kHz

      trst_only separate trst_push_pull

      jtag_ntrst_delay: 300

      Info : clock speed 1000 kHz

      Info : JTAG tap: quark_se.cltap tap/device found: 0x0e765013 (mfg: 0x009, part: 0xe765, ver: 0x0)

      Enabling arc core tap

      Info : JTAG tap: quark_se.arc-em enabled

      Enabling quark core tap

      Info : JTAG tap: quark_se.quark enabled

      Processor type: arc-em

      Warn : target is still running !!

      Error: tapstatus invalid - scan_chain serialization or locked JTAG access issues

      redirect to PM, tapstatus=0xffffffff

      Error: submit_pir TS_PIR_BIT did not clear, TS = 0xffffffff

      Error: submit_instruction_pir error submitting pir

      Polling target quark_se.quark failed, GDB will be halted. Polling again in 100ms

      redirect to PM, tapstatus=0xffffffff

      Error: submit_pir TS_PIR_BIT did not clear, TS = 0xffffffff

      Error: submit_instruction_pir error submitting pir

      Polling target quark_se.quark failed, GDB will be halted. Polling again in 300ms

      adapter speed: 1 kHz

      redirect to PM, tapstatus=0xffffffff

      Error: submit_pir TS_PIR_BIT did not clear, TS = 0xffffffff

      Error: submit_instruction_pir error submitting pir

      Polling target quark_se.quark failed, GDB will be halted. Polling again in 700ms

      Error: target running, halt it first

      Runtime Error: C:/IntelSWTools/ISSM_2016.2.094/tools/debugger/openocd//scripts/target/quark_se.cfg:110:

      in procedure 'clk32M'

      in procedure 'mww' called at file "C:/IntelSWTools/ISSM_2016.2.094/tools/debugger/openocd//scripts/target/quark_se.cfg", line 110

       

      In attachement my 'openocd' folder from '~\IntelSWTools\ISSM_2016.2.094\tools\debugger\'

      And it's my preferences in ISSM:

      What could it be?