1 Reply Latest reply on Sep 27, 2017 7:00 AM by Intel Corporation

    Flashing Custom board with IntelCurie (C1000) via Jtag (olimex-arm-usb-ocd-h)

    eugene.redkin

      Helllo! When I'try to flash I obtained next error log:

      Open On-Chip Debugger 0.8.0-dev-g377d3f24-dirty (2017-04-11-19:24)
      Licensed under GNU GPL v2
      For bug reports, read
          http://openocd.sourceforge.net/doc/doxygen/bugs.html
      Info : only one transport option; autoselect 'jtag'
      adapter speed: 1000 kHz
      trst_only separate trst_push_pull
      jtag_ntrst_delay: 300
      Info : clock speed 1000 kHz
      Info : JTAG tap: quark_se.cltap tap/device found: 0x0e765013 (mfg: 0x009, part: 0xe765, ver: 0x0)
      Enabling arc core tap
      Info : JTAG tap: quark_se.arc-em enabled
      Enabling quark core tap
      Info : JTAG tap: quark_se.quark enabled
      Processor type: arc-em
      Warn : target is still running !!
      Error: tapstatus invalid - scan_chain serialization or locked JTAG access issues
      redirect to PM, tapstatus=0xffffffff
      Error: submit_pir TS_PIR_BIT did not clear, TS = 0xffffffff
      Error: submit_instruction_pir error submitting pir
      Polling target quark_se.quark failed, GDB will be halted. Polling again in 100ms
      redirect to PM, tapstatus=0xffffffff
      Error: submit_pir TS_PIR_BIT did not clear, TS = 0xffffffff
      Error: submit_instruction_pir error submitting pir
      Polling target quark_se.quark failed, GDB will be halted. Polling again in 300ms
      adapter speed: 1 kHz
      redirect to PM, tapstatus=0xffffffff
      Error: submit_pir TS_PIR_BIT did not clear, TS = 0xffffffff
      Error: submit_instruction_pir error submitting pir
      Polling target quark_se.quark failed, GDB will be halted. Polling again in 700ms
      Error: target running, halt it first
      Runtime Error: C:/IntelSWTools/ISSM_2016.2.094/tools/debugger/openocd//scripts/target/quark_se.cfg:110: 
      in procedure 'clk32M' 
      in procedure 'mww' called at file "C:/IntelSWTools/ISSM_2016.2.094/tools/debugger/openocd//scripts/target/quark_se.cfg", line 110
      

       

      In attachement my 'openocd' folder from '~\IntelSWTools\ISSM_2016.2.094\tools\debugger\'

      And it's my preferences in ISSM: