2 Replies Latest reply on Sep 7, 2017 1:04 PM by Intel Corporation

    DRAM PUFs Enable Issue.


      Hello Sir,

      Sir I have completed the flash.cap build process successfully after that I have copied these file and insert into the Galelio board and reboot it by serial console.



      I want to know

      (1) Where and When Will I do the above steps ?

      (2) during reboot process or after reboot process?



      The step is :


      "Connect the board using, and reboot the board, you are now using the new firmware with DRAM PUF enabled."


        e.g. By pressing ‘3’-‘1’-‘0’-‘1’, you will take one measurement of 96KB PUF initialized with all 0’s with 120s decay.



      Please guide me.




      Thank you.