-
1. Re: Couldnt upload sketch to Galileo from Arduino1.8.4
FGT Aug 29, 2017 9:05 AM (in response to Aarthi)Hi Aarthi,
Please tell us the steps you followed from the initial stating point IoT - Getting Started with the Intel® Galileo Board on Windows* | Intel® Software up to the point of the error you found. Please add screenshots so we will see what you see along the way.
HTH,
Fernando.
-
2. Re: Couldnt upload sketch to Galileo from Arduino1.8.4
Aug 31, 2017 2:08 PM (in response to Aarthi)This message was posted on behalf of Intel CorporationHi Aarthi,
Do you still need assistance with this thread?
-Sergio A
-
3. Re: Couldnt upload sketch to Galileo from Arduino1.8.4
Aarthi Sep 4, 2017 12:50 AM (in response to Aarthi)Hi Sergio,
Yes, Sorry I couldn't get back to you sooner. Yes, regarding the steps i followed, I installed Arduino 1.8.4 for the Galileo board.
And i Couldn't find the Intel Galileo board under the tools -> board option
So i downloaded it from "Boards Manager".
And i have selected the port "COM 3(Intel Galileo).
When i tried on the basic blink sketch, it shows error. What can be done? please advice.
Thanks!
-
4. Re: Couldnt upload sketch to Galileo from Arduino1.8.4
FGT Sep 4, 2017 6:25 PM (in response to Aarthi)And i Couldn't find the Intel Galileo board under the tools -> board option
So i downloaded it from "Boards Manager".
And i have selected the port "COM 3(Intel Galileo).
When i tried on the basic blink sketch, it shows error. What can be done? please advice.
Actually, if you had followed the step-by-step guide referred to above, you would not have had that problem. Please
Please follow the steps from the initial stating point at IoT - Getting Started with the Intel® Galileo Board on Windows* | Intel® Software up to the point of the error you find. Please add screenshots so we will see what you see along the way.
Besides:
a) Are you using Intel Galileo or Intel Galileo Gen2?
b) Are you developing in Linux or windows?
Fernando.