1 Reply Latest reply on Feb 13, 2017 5:01 PM by Intel Corporation

    Tuchuck Board add jumper selection for GPIO to allow for 3.3v pullups, or 5 volt pullups

    floydg

      The Tuchuck board GPIO are 1.8v for J12 and J13.

       

      To interface GPIOs to currently available shields/hats/peripheral boards pullup resistors need to be added to the hardware, to obtaing the typically 5v, or 3.3v available on the peripheral board,

       

      The Tuchuck board does not currently allow this capability. Additional resistors, and jumpers should be designed into the tuchuck schema.