1 2 Previous Next 19 Replies Latest reply on Mar 14, 2017 9:00 AM by Intel Corporation

    MQTT library not working on bootup in Galileo Gen 2.0

    Loop

      I am trying to run Pubsub client on Galileo gen 2.0. the code runs fine but does not start when I boot up the board. I need to upload it every time through the IDE in order to execute the code.

       

      The blinky code runs fine on boot up.

       

      The firmware version of my board is

       

      root@galileo:~# cat /etc/version

      201606081532

       

      The MQTT client library can be found here: https://github.com/knolleary/pubsubclient

        1 2 Previous Next