4 Replies Latest reply on Jan 17, 2017 1:33 AM by Intel Corporation

    X710 - eeprom check failed - Tx/Rx traffic disabled

    JayN

      Hello, I am using following Ethernet controller on one of our systems, and once in a while I run into following error after bootup, resulting in the port not sending/receiving packets. 

       

      2016-12-13T01:06:55.499000+00:00 kernel: i40e 0000:20:00.3: eeprom check failed (-2), Tx/Rx traffic disabled

       

       

      Following is the current version we use (which is quite old; we are in process of upgrading).  But does anyone know if this is a known issue and may be fixed in an upgraded driver and/or NVM?

       

      System# lspci -s 0000:20:00.3

      20:00.3 Ethernet controller: Intel Corporation Ethernet Controller X710 for 10GBASE-T (rev 01)

      System# ethtool -i eth1

      driver: i40e

      version: 1.3.47

      firmware-version: 4.43 0x80001c3f 1.1018.0

      bus-info: 0000:20:00.3

      supports-statistics: yes

      supports-test: yes

      supports-eeprom-access: yes

      supports-register-dump: yes

      supports-priv-flags: yes

      System#

      Thank you very much!