2 Replies Latest reply on Dec 25, 2016 4:38 AM by Intel Corporation

interfacing I210IS to Broadcom 5461S PHY in SGMII mode

70.3_guy Dec 9, 2016 10:48 AM

I have an I210IS device, interfacing to Broadcom BCM5461S in SGMII mode.

Currently I don't have MDIO from I210 connected to PHY, I loaded "Dev_Start_I210_Sgmii_NOMNG_16Mb_A2_3.25_0.03.bin" driver into the device flash.

The PHY is set to SGMII mode. I have signals on both RX and TX line, but no link

Any help would be appreciated

1. Re: interfacing I210IS to Broadcom 5461S PHY in SGMII mode

Dec 12, 2016 3:38 AM (in response to 70.3_guy)

This message was posted on behalf of Intel Corporation

Hi 70.3_guy,

Thank you for your post. We're currently checking your question and will update this thread as soon as possible.

regards,
Vince
Like Show 0 Likes(0)

Actions
2. Re: interfacing I210IS to Broadcom 5461S PHY in SGMII mode

Dec 25, 2016 4:38 AM (in response to Intel Corporation)

This message was posted on behalf of Intel Corporation

Hi 70.3_guy,

Please check out the embedded communities link below, you may also post your query in that section.

https://embedded.communities.intel.com/thread/12314

regards,
Vnce
Like Show 0 Likes(0)

Actions