Did you check the datasheet for that information, please see page 46
Also, you can check here:
I hope this can help.
Thank you for your reply. I did check those out. It is still not clear what the current available for the LEDs is. The HDD activity have a pull up resistor. I have seen 330 and 750 ohms. The LED's for the power switch have no mention of a resistor nor current. So it is hard to configure an LED such it would draw too much current!
Any info on that? Of is possible, do you have the secs on the switch and HDD activity LED's in the NUC device already?
The only information I could get was on the front panel header, the HDD indicator LED pins have 5 V and a 750 pull-up resistor. Does this mean only 7 mA available for the LED? For the power standby indicator LED, all that can be founf id 5 V available.
In order to configure LEDs using the front panel header, I need to know the correct current available. Do you know what it is?