7 Replies Latest reply on Sep 29, 2016 1:03 PM by Intel Corporation

    Intel Edison GPIO state at boot up

    Jele95

      Hi,

      I have been looking for a solution on this forum but unfortunately never found a solution to my problem.

       

      I'm using the Intel Edison to send a PWM signal to 2 motor controllers that will then make motors turn.

      I'm using GPIO12 and GPIO13.

       

      At the edison boot up those two pins are high, which make my motors turn.

       

      Would you have a way to set those GPIO to low at boot up ?

       

      Thanks