0 Replies Latest reply on Jun 17, 2016 2:44 AM by jobs_intel

    How to clear CMOS on DK 300

    jobs_intel

      If comes across No display issue even after rebooting on DK 300 try clearing CMOS.

       

      To clear CMOS, Turn of the gateway and remove power.
      Open the chassis then remove CMOS battery.

      Short the battery terminal on the main board with a small screwdriver.

      Else leave the system from few minute without CMOS battery.

      Connect the battery back to the main board.
      Close the chassis and power on the gateway.

       

      If above steps didn't work flash BIOS using dediprog .

       

      Please refer following picture for the location of the battery

       

       

      Last Validated Info:

      IDP Version: 3.1

      RCPL: 0013

      Device: DK300