1 Reply Latest reply on Jun 20, 2016 4:18 PM by Intel Corporation

    Ubilinux didn't flash correctly; says Load Kernel Modules failed and boots into rescue mode

    mtveezy

      I followed the instructions here to flash ubilinux onto my edison arduino breakout board and it seemed to flash correctly, however I never saw the board reset for the 2 minutes after, so I manually reset twice by pressing the rest button. The first time I did `sudo scren /dev/ttyUSB0 115200` to the newly flashed Edison I got this screen:

      ubilinux_failed.png

      So I did `systemctl status systemd-modules-load.service` as it suggested and well now I'm not sure what went wrong. Help?

      rescue.jpg

       

      I'm running Ubuntu 15.10, and I just flashed with the Yocto image and phone flash tool lite sucessfully minutes prior to this.