0 Replies Latest reply on May 10, 2016 11:08 PM by Steve_IRCSA

    S2600 Server shutdown issue

    Steve_IRCSA

      Just has a S2600 server shutdown without notice. Following is from Event logs just like some thought on what is most likely cause. Server is UPS protected and other servers on same UPS had no issues.

       

      Physical removal of power cords from power supplies and reset server booted fine?

       

      1500 05/11/2016 14:01:19 Pwr Unit Status Power Unit reports the power unit has suffered a failure - Deasserted

      1499 05/11/2016 14:01:17 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Deasserted

      1498 05/11/2016 14:01:12 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Asserted

      1497 05/11/2016 14:01:11 Pwr Unit Status Power Unit reports the power unit has suffered a failure - Asserted

      1496 05/11/2016 13:59:44 Pwr Unit Redund Power Unit reports redundancy has been lost and there are insufficient resources to maintain normal operation - Asserted

      1495 05/11/2016 13:59:43 PS2 Status Power Supply reports the power supply's input (AC/DC) has been lost - Asserted

      1494 05/11/2016 13:59:43 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Asserted

      1493 05/11/2016 13:59:42 Pwr Unit Redund Power Unit reports redundancy has been lost, but the unit is still functioning with the minimum amount of resources needed for normal operation - Asserted

      1492 05/11/2016 13:59:42 Pwr Unit Redund Power Unit reports redundancy has been lost - Asserted

      1491 05/11/2016 13:59:41 PS1 Status Power Supply reports the power supply's input (AC/DC) has been lost - Asserted

      1490 05/11/2016 13:57:53 Button Button / Switch reports the power button has been pressed - Asserted

      1489 05/11/2016 13:11:18 BMC FW Health Management Subsystem Health 'P2 Therm Ctrl %' sensor has failed and may not be providing a valid reading - Asserted

      1488 05/11/2016 13:11:18 BMC FW Health Management Subsystem Health 'P1 Therm Ctrl %' sensor has failed and may not be providing a valid reading - Asserted

      1487 05/11/2016 13:09:55 BMC FW Health Management Subsystem Health 'SSB Temp' sensor has failed and may not be providing a valid reading - Asserted

      1486 05/11/2016 13:09:55 BMC FW Health Management Subsystem Health '' sensor has failed and may not be providing a valid reading - Asserted

      1485 05/11/2016 13:09:54 BMC FW Health Management Subsystem Health 'P2 Therm Margin' sensor has failed and may not be providing a valid reading - Asserted

      1484 05/11/2016 13:09:54 BMC FW Health Management Subsystem Health 'P1 Therm Margin' sensor has failed and may not be providing a valid reading - Asserted

      1483 05/11/2016 13:09:37 BB +1.05V P1Vccp Voltage reports the sensor is in a low, critical, and going lower state - Asserted

      1482 05/11/2016 13:09:37 BB +1.05V P1Vccp Voltage reports the sensor is in a low, but non-critical, and going lower state - Asserted

      1481 05/11/2016 13:09:12 Pwr Unit Status Power Unit reports the power unit has suffered a failure - Deasserted

      1480 05/11/2016 13:09:10 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Deasserted

      1479 05/11/2016 13:09:05 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Asserted

      1478 05/11/2016 13:09:05 Pwr Unit Status Power Unit reports the power unit has suffered a failure - Asserted

      1475 05/11/2016 13:09:12 Pwr Unit Status Power Unit reports the power unit has suffered a failure - Deasserted

      1474 05/11/2016 13:09:10 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Deasserted

      1473 05/11/2016 13:09:05 Pwr Unit Status Power Unit reports the power unit is powered off or being powered down - Asserted

      1472 05/11/2016 13:09:05 Pwr Unit Status Power Unit reports the power unit has suffered a failure - Asserted