2 Replies Latest reply on May 19, 2016 8:55 AM by Intel Corporation

    NUC5i5RYH goes to Standby instead of Shutdown using Remote Control




      I just setup my NUC5i5RYH with Windows 10. BIOS Version is 0355.

      I enabled Custom IR in BIOS and set it to RC6 Mode.


      If I push the Power Off Button on my Remote, the NUC goes to Standby (Energy Saving) instead of doing a Shutdown.


      In the Energy options of Windows I set the actions to start when "pushing the power button" and pushing the energy saving button.

      For the power button I set "Shutdown". For the energy saving button I can only select "do nothing", standby and hibernate.


      If I chose do nothing for enery saving button, the NUC does nothing when I push the power off on the remote.

      Is there a Way to change this? Is there a way to setup the CIR to do a pwer button push?