If the system worked before with other OSs, and you did not change hardware, then the system should be just fine.
You did not say how you installed Win 7. Was a clean install? or upgrade?
It appears you have a RAID issue at BIOS level. It can be as simple as a loose cable.
Also, the RAID daughter board can get very hot. And the performance can degrade. I believe that card can also use a backup battery. It can complain if the battery is discharged....
Good point on the activation key and mem module. I will try that.
I am unable to enter Raid config. Message may or may not state "entering raid console after post completes" (depending on how soon you hit ctl G)
But goes no further.
to answer other questions: W7 was a clean install, no battery back up on raid, I did check cables but doesn't hurt to check again. all hardware changes were done before I started testing OS's and did the Bios update.
removed the midplane memory module and activation key and successfully booted into Bios.
cleaned and re-installed. same issue.
Removed the 5 HDD's and was able to hit "C" and get into the raid config. of course there was nothing there to config. quit and shut it down.
when the unit starts I do see the HDD's led's blinking on the backplane.
Unit just won't post with everything connected. I guess it has to be a bad backplane or midplane. I'm not sure what else to try except for replacing them.
Any suggestions appreciated.
I can get into the raid config utility with the drives removed. I's ctrl C at this point. Which gets me into the configuration utility
Put the drives back in, I removed the activation key, F2 into bios, and I can see the drives in the bios.
It also shows them on the screen before system goes into intel boot agent. "searching for drives @ HBA 0" and it does list all 5. then it proceeds to the intel boot agent. of course it's hung at that point since there is no network boot available.
do these activation keys go bad?