I have recently tried to install a MSI Radeon HD 6670 2GB GDDR3 onto my board. However, after install while it did power on and display the BIOS splash screen, it would lock up at that point. Being able to think of nothing else and receiving no useful suggestions from MSI customer support, I decided to try a BIOS update to see if that might fix the problem.
Problem is, no matter how or which BIOS update I choose to download & install, whether it be the newest one or any inbetween from the revision I currently have. I receive the following:
Current revision: DPP3510J.86A.0326.2008.0227.1102
Updating revision: DPP3510J.86A.0572.2009.0715.2346
Preparing image for Intel(R) Management Engine firmware ... [done]
Preparing image for recovery firmware ... [done]
Preparing image for main firmware ... [failed!] (30608 bytes overflow)
Flash update failed!
Technical information: (0x80000000000000B, 1267)
Depending on the BIOS version I am trying to install, this differs only with (???? bytes overflow). But it literally with EVERY single BIOS version I have downloaded and tried. I have used the .EXE files, I have downloaded Intel Integrator Toolkit and tried it from there, and I have downloaded the ISO files as well and booted from CD. None of these are successful, and the problem is becoming increasingly frustrating.
Any help is appreciated. Thanks in advance.
Did you remove the video card before attempting to flash the BIOS? If not try that.
According to the TPS, the DG33TL supports PCI Express Rev 1.0a. Correct me if I am wrong, but the card you are using is PCIe 2.1.
I believe there is a power output difference between PCIe 2.1 and PCIe 1.0a. The firmware might address this, but I didn't see anything in the release notes.
Yes, I took the new card out and put the old one in the flash the BIOS (MSI GeForce 8400 GS). To my knowledge PCIe is fully backwards compatible, therefore any PCIe card should work it would just run at PCIe 1.0 speeds. I did my best to research this before purchasing the card.
It wouldn't. I've cross checked my logic with a colleague and I was a bit off.. embarrassing.
Did you try different BIOS revs as well as different flashing methods? I notice you only mentioned 326.2008 to 326.2009... that's the same BIOS rev from different years. Have you tried rev 407?
Problem has become increasingly weirder...
After trying to install the BIOS via the jumper recovery method, the BIOS update fails (again). I turn off the computer, put the jumper back on, and turn it back on. Now the computer boots up with the new video card installed! Fantastic, problem solved I figure. Windows boots up, I download and install the latest drivers from the AMD site, and reboot. Lock up again at the BIOS splash screen. I do the same method to try to boot into Windows again (purposely fail the BIOS recovery update, reboot), and while BIOS posts successfully it now locks up on the Windows splash screen.
What is going on?