How to Run the Flashall Script

Version 13

    Download and extract the latest "Yocto* Complete image" from  IoT - Intel® Edison Module Downloads | Intel® Developer Zone

     

    On Linux

     

    1. Open  a new Terminal session and run:

     

    sudo apt-get install dfu-util
    

     

    2. Go to the folder where the "Yocto* Complete image" files were extracted and run:

     

    sudo ./flashall.sh
    

     

    3. Plug the board to the PC and reboot the board when the process asks for it. Then wait for the process to be completed.

     

     

    On Windows

     

    1. Download the attached file dfu-util.exe and put it inside the folder where the "Yocto* Complete image" files were extracted.

    2. Download the latest copy of libusb-1.0.dll from the dfu-util site and put it inside the folder where the "Yocto* Complete image" files were extracted.

    3. Open the Command Prompt (cmd.exe) and go to the folder where the "Yocto* Complete image" files are and run:

     

    flashall.bat
    

     

    4. Plug the board to the PC and reboot the board when the process asks for it. Then wait for the process to be completed.

     

    Direct file link:At the time of writing, 0.8 was the latest binary release. Download dfu-util.exe and libusb-1.0.dll.

     

     

    On Mac

     

    1. Open a new Terminal session and run the following commands:

     

    ruby -e "$(curl -fsSL https://raw.githubusercontent.com/Homebrew/install/master/install)"  
    brew install dfu-util coreutils gnu-getopt
    

     

    2. Go to the folder where the "Yocto* Complete image" files were extracted and run:

     

    ./flashall.sh
    

     

    3. Plug the board to the PC and reboot the board when the process asks for it. Then wait for the process to be completed.