Signal Fish Tutorial: Configure End Device module

Version 5

    The steps to create an end device are similar to the steps for creating a Coordinator device. Steps 1 and 2 are exactly the same: connect your device, then select it to configure. There are only 2 settings that differ from this end device:

    1. The function set needs to be set as ZigBee Device AT using the firmware 28A7 (select a newer version if available).
    2. Configure the DL address. ZigBee Series 2 modules share the same DH address of 0013A200. The DL address for every module is unique per module.
    .
    < Configure Coordinator moduleViewing your network >

    Part 1: XBee configuration
    Part 2: Rig construction
    Part 3: Circuit