Thank you for your post. Note that the 1030 adapter does support A2DP.
Make sure that you have the latest drivers for all of your hardware. There are some additional settings in windows that will need to be setup:
After the device is paired and “working”, you would need to go into control panel, and select Bluetooth Devices. From there, open the properties of the speakers, and make sure that every service is enabled. Once that is done it should work. If it doesn’t, you can also try removing the device from within the Bluetooth panel, and then repair the device.
You may also need to manually set the audio output as Creative D80. This can be done in control panel under sound and audio devices section on your computer, select Creative D80 as your default output device after pairing is complete.
I hope this helps.
Dear Nathalie, I think something in the communication goes wrong. I have the N 130 not the 1030. Here is the link from the card i have. http://www.intel.com/content/www/us/en/processors/centrino/centrino-wireless-n-130-brief.html But thank you for your response, Arno (AWPC)
