Intel Communities: Message List

Re: Help with DX58SO2 Motherboard Troubles

webadmin@intel.com — Mon, 11 Jul 2011 17:53:42 GMT

I had the same issue with my board with this update. I went into BIOS and reset defaults, then tried again. It worked the first time after that. Good luck.

Re: DX58SO2 wont boot displays "00"

webadmin@intel.com — Sun, 24 Apr 2011 18:13:53 GMT

under intel dyamic power every option is set to enable which i believe are defaults

Re: DX58SO2 wont boot displays "00"

webadmin@intel.com — Sat, 23 Apr 2011 06:02:30 GMT

You're welcome. Hope you guys get it all sorted out. Good luck

Re: DX58SO2 wont boot displays "00"

webadmin@intel.com — Sat, 23 Apr 2011 05:13:59 GMT

I received the replacement board on March 2nd. RMA'd through newegg since it failed within a couple of days of purchase.

CPU: 980X @ 3.33ghz

CPU Cooler: Corsair H70

RAM: 12GB (6 sticks) Corsair Dominator @ 1600mhz using xmp profile (TR3X6G1600C8D)

MB: Intel DX58SO2 (AA G10925-205) current BIOS 779

Graphics: 2- EVGA GTX580 in SLI

PSU: Corsair AX1200

HDD: 128GB Corsair P3 SSD, 1TB WD Caviar Black (on the Blue connectors)

Case: CM Storm Scout

OS: Windows 7 HP 64-bit

Re: DX58SO2 wont boot displays "00"

webadmin@intel.com — Sat, 23 Apr 2011 04:21:00 GMT

Getting my board replaced solved my problem. Not a single failed POST since it was replaced.

Re: DX58SO2 wont boot displays "00"

webadmin@intel.com — Sat, 26 Mar 2011 02:38:39 GMT

Since the board failed within a few days of purchase, I just sent it back and got a new board.

Re: DX58SO2 wont boot displays "00"

webadmin@intel.com — Thu, 03 Mar 2011 04:18:05 GMT

RMA'd the board, all is well. Turns out it would not communicate with the PCIe bus.

DX58SO2 wont boot displays "00"

webadmin@intel.com — Sun, 20 Feb 2011 02:51:19 GMT

I got this board this week and it was working great until this morning. I am using the 980X not OC'd Corsair Dominator 6GB 3 channel Ram. When powering up the board the POST display shows "00" almost immediately. The cpu and memory init LEDs blink then go solid, so I assume the CPU and RAM are ok. I have tried unplugging the power and removing the battery for almost 2 hours. I get beeps if i power it on without Ram but no beeps if i power on without graphics card installed. Thanks for any advice you can give