Intel Communities: Message List

Re: Intel(r) SSD Toolbox is ready to go!

webadmin@intel.com — Tue, 22 Dec 2009 06:14:12 GMT

Took about 1 hour on 80GB with 20 restore point. After deleting all but 1 restore point, it ran in about 10 min.

Re: How Long Should Optimizer Run in Toolbox?

webadmin@intel.com — Tue, 22 Dec 2009 06:11:24 GMT

Using Toolbox 1.2 on 80GB, it tool 1 hour with about 20 restore points... After I deleted all but the most recent restore point the Toolbox optimizer ran in about 10 min.

Re: Use old Toolbox with new firmware?? New Toolbox ETA??

webadmin@intel.com — Thu, 03 Dec 2009 14:57:31 GMT

Hi all again, can anyone please tell me how long the toolbox Optimizer took to run? Mine runs for only a a few seconds and says its ready for use. But I'm not so sure. Thanks

Re: Use old Toolbox with new firmware?? New Toolbox ETA??

webadmin@intel.com — Wed, 02 Dec 2009 16:19:10 GMT

Anyone know about how much time the toolbox Optimizer takes to do it's thing? When I run the Optimizer it finishes almost immediately and says Ready. I don't believe it.

Re: X25-M G2 Update failed, reboot, says firmware already updated

webadmin@intel.com — Wed, 02 Dec 2009 09:13:15 GMT

I too encountered the same thing. And I saw no difference in benchmarks after upgrade. It's like the upgrade never happened. But firmware now says it's 02HD.

Re: Can some of you post your POST firmware crystal disk results for 80 gig G2

webadmin@intel.com — Wed, 02 Dec 2009 03:36:00 GMT

Can anybody think of a reason why my crystal marks are low? especially the 4Kread.

Was the same before the update to 02HD

I'm using 80GB G2 drive in a Dell E6400. All drivers are correct per the many posts on this site